Disconnect the negative battery terminal. Look for the hood safety switch.
It is usually mounted on or under the dashboard on the driver’s side of the vehicle.
Viper remote start not working after dead battery. After about a month of a dead battery the remote won't talk to the brain (shipped my car here to s. Turn the key to off position. Drove it for about 30 mins and parked it.
Then try your lock/unlock to see if the viper responds. Yes, believe it or not, that remote control on your keychain does take batteriesand, after a period of time, they are going to get weak (diminishing the range) and eventually go dead. Turn the key to on position.
Now it will start the engine with the remote start but 5 seconds later it shuts the engine off. Try unplugging the 6 pin harness from the viper brain for a couple of minuets, then plug it back in to see if the viper brain resets. Here are some of the steps that i did:
Or try entering one of the menus, again to see if the viper unit is responding with horn honks or siren chirps, indicating a selected menu. They could have bumped it while replacing the battery and bent the bracket so the sensor reads open even when the hood is closed. This video will show how to reset viper car remote starter.
Im guessing the battery is weak because it does not turn over like it used to and remote start does not work. The car starts by push button but not remote start any more. Check if your remote is paired correctly;
To solve this, you will need to start by replacing the batteries with a new one and see if it works. My husband has a remote start the dealership put in, and if you're not close to the vehicle to hear the horn beep, you're out of luck. The viper remote start/car alarm was working just fine until this weekend.
This may not be a typical case, but it can sometimes occur. It should be pretty easy to follow along with this video. Press and hold the disarm button on your remote until the alarm turns off.
Discussion starter · #1 · apr 21, 2008. I was gonna pick up a battery at costco today for 99.00 but passed. It is a black wire with a white stripe and is located in the viper remote start system.
It should be near the drivers side hood hinge. I can start and run the vehicle normally with the key. Reattach the negative battery terminal.
Please subscribe our channel for more v. Enormis stocks lots of different batteries, and most likely has the correct ones in stock for you. By mmsstar » thu dec 12, 2013 9:18 pm.
To do this, you will need to locate the valet switch or button associated with the aftermarket alarm system. How to bypass a viper car alarm. I jumped it the car with a booster pack.
Remote start not working after car battery replacement. Hi guys, i have a prostart ct3471 tw remote starter that stop working after my car battery die. Toggle the key from on and off to exit out the valet mode 2.