Make sure the positive (+) symbol is facing you. Remove the battery cap for access to the battery.
Replace with the new battery, taking note of the positive and negative terminal directions.
How to change battery in mazda key fob 2017. Up to 6 keys can be used with the keyless functions per vehicle. The key fob will need to be reprogrammed to the vehicle as when the battery was replaced in the key fob, the key was reset. Help is just a phone call away!
Locate the transmitter and ground it. Make sure the rubber ring does not come off at this point. Line up the back cover with the other half of the fob and gently pop them back together.
Pull the key out of the slot and set it aside in a safe place. How to change battery in mazda key fob. Like we mentioned, if you need assistance at any point.
Make sure that the two halves of the fob are flush together at every edge. After replacing the battery in the key fob remote, you will need to reprogram the remote to the vehicle. Set aside the round cap aside in a safe place.
Additional keys can be obtained at an authorized mazda dealer. Remove the key fob battery cover from your mazda remote. Test new key fob battery
Locate the small switch on the back side of the fob. Make sure to keep key fob parts in a neat space so that it doesn’t go missing. How to change battery in mazda key fob 2016.
Most often, the batteries are cheap, easy to replace, and easy to come by. Pull out the dead key fob battery from the mazda keyless remote. Place the back mazda key fob case aside.
Remove the battery cap, set it next to the key fob case, and follow these instructions: Your mazda key fob battery should be fully exposed. If the other remote works, you may have a bad battery.
This is why nothing is working with the key fob. If the ring gets scratched, it must be replaced before continuing. Slide the switch to release the metal emergency / backup ignition key.
The first step is to turn over the key fob. If the ring is undamaged, leave it in place while you put your new battery in the key fob with the positive (+) side up, facing you. Follow these final steps and get back on the tampa roads:
Open the key fob case and put a new battery in. Replacing the battery about once a year is recommended because the key warning light/indicator light may not illuminate or flash depending on the rate of battery depletion. The process of actually replacing your mazda key fob battery should only take a moment once the fob is open.
Put the emergency key back into the key fob. Take out the battery, but be careful of the rubber ring. Make sure you perform each step carefully to avoid damaging your mazda key fob.
Set the back cover of the fob aside in a safe place. Bring all keys to an authorized mazda dealer. Replacing your mazda key battery.
It usually takes 10 seconds. The positive is on top, while the negative side of the button cell battery is facing the key fob. Gently pry off the battery socket cap with the small flat head screwdriver.
How to open a mazda key fob replace the battery dead key fob tips. Do this for every remote you have up to four. Remove the battery cap, and set it next to your key fob case.
Carefully snap the fob cover back into place. Locate the round black plastic battery cap. Push the buttons that lock and unlock the remote until you hear it cycle.