I have a 2004 jeep liberty with an intermittent starting problem. If still no click, then it can be the neutral safety switch in the transmission.
Asked by tdoodle may 06, 2014 at 12:57 pm about the 2004 jeep liberty.
2004 jeep liberty starter problems. The relay makes a faint click. It is highly likely that if the engine is cranking, but not starting that it has thrown an obdii code. I have a 2004 jeep liberty, the starter is new but the car does not crank, we've changed the battery, the ignition switch, some of the relays and so many parts and the car still does not crank.
Replace starter solenoid, starter contacts, starter assembly or repair starter circuit as required. Did not write up a work order. Never know when it is going to happen.
Your jeep liberty‘s ignition switch is one of the most vital items on the entire vehicle.if it fails, the entire vehicle won’t be able to run. Problem with your 2004 jeep liberty? Like will go to the store and come out and it will not start.
Was an expensive replacement, but the mechanic showed me the part and also told me it was a common failure in liberty's (along with rear window motors). All you hear is a single click or repeated clicking coming from the engine compartment. It only cranks when i bypass the starter relay fuse.
Asked by tdoodle may 06, 2014 at 12:57 pm about the 2004 jeep liberty. I have a 2004 jeep liberty wont start. Engine cranks → won’t start.
The most recently reported issues are listed below. 1/16/04 jeep liberty hard to start, pulls to right, jeep shakes & vibrates hard to control, seat belts do not work, seat rippling, car stops dead it its tracks, dealer fixed lower ball joints again on 2/13/04 at 23,850 miles. 2004 jeep liberty problems the main categories of concern for the 2004 jeep liberty also deal with the windows and windshield category, with owners of this car focusing on the problems with the windows failing, the windows dropping on the floor, and the rear window and door not being able to close.
The engine needs air, fuel, and a spark in order to run. It cranks but will not start, and only after it has been run for a little while. There are a lot of issues that can cause your liberty to crank, but not start.
Please also check out the statistics and reliability analysis of the 2004 jeep liberty based on all problems reported for the 2004 liberty. Had battery, starter and alternator checked and all tested good. When i turn the key, the lights come on, the little bell dings but car will not start or turn over.
One problem related to starter has been reported for the 2004 jeep liberty. Diagnosing a starter problem on a 2004 jeep liberty is not difficult. Best is to open the hood and let someone listen while trying to start.
We’ve compiled some of the most common symptoms of a bad ignition switch.these include stalling issues, not starting, and no power to the radio or accessories. The 2008 jeep liberty car makes a clicking noise but won’t start: Our list of 15 known complaints reported by owners can help you fix your 2004 jeep liberty.
When i turn the key, the lights come on, the little bell dings but car will not start or turn over. Under the box’s lid is a diagram depicting the type and location of the fuse and relay for the starter. Idle speed is too low because the engine computer has not relearned minimum throttle.
Joined feb 18, 2015 · 1 posts #15 · feb 18, 2015. If playback doesn't begin shortly, try restarting your device. If you turn the key to the “start” position, but the engine won’t crank;
The fuse and relay for the starter are located on the driver’s side fenderwell in the electrical component box. If it doesn´t click, then swap this relay with a same one in the fuse/relay box and try again.